Filter
Top Products
Chapter 14 Tutorials
NBG4615 User’s Guide
108
Follow the steps below to configure the wireless settings on your NBG4615.
The instructions require that your hardware is connected (see the Quick Start Guide) and you are
logged into the Web Configurator through your LAN connection (see Section 5.2 on page 43).
1 Make sure the WLAN switch (at the back panel of the NBG4615) is set to ON.
2 Open the Configuration > Wireless LAN > General screen in the AP’s Web Configurator.
3 Confirm that the status of wireless LAN is ON.
4 Enter SSID_Example3 as the SSID and select Channel-06 as the channel. Click Apply.
5 Go to the Configuration > Network > Wireless LAN > Security screen. Set security mode to
WPA-PSK and enter ThisismyWPA-PSKpre-sharedkey in the Pre-Shared Key field. Click
Apply.l