Filter
Top Products
Chapter 8 Easy Mode
NBG4615 User’s Guide
65
Note: You can enable the Wireless function of your NBG4615 by first turning on the
switch in the back panel.
Figure 40 Wireless Security
The following table describes the general wireless LAN labels in this screen.
Table 25 Wireless Security
LABEL DESCRIPTION
Wireless
Network Name
(SSID)
(Service Set IDentity) The SSID identifies the Service Set with which a wireless
station is associated. Wireless stations associating to the access point (AP) must
have the same SSID. Enter a descriptive name (up to 32 keyboard characters) for
the wireless LAN.
Security mode Select WPA-PSK or WPA2-PSK to add security on this wireless network. The
wireless clients which want to associate to this network must have same wireless
security settings as this device. After you select to use a security, additional options
appears in this screen.
Select No Security to allow any client to connect to this network without
authentication.
Wireless
password
This field appears when you choose wither WPA-PSK or WPA2-PSK as the
security mode.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
Verify
password
Type the password again to confirm.
Apply Click Apply to save your changes back to the NBG4615.
Cancel Click Cancel to close this screen.
WPS Click this to configure the WPS screen.
You can transfer the wireless settings configured here (Wireless Security screen)
to another wireless device that supports WPS.