Filter
Top Products
Chapter 12 WISP Mode
NBG4615 User’s Guide
91
12.3.1 Setting your NBG4615 to WISP Mode
1 Log into the Web Configurator if you haven’t already. See the Quick start Guide for instructions on
how to do this.
2 To set your NBG4615 to WISP Mode, go to Maintenance > Sys OP Mode > General and select
WISP Mode.
Figure 61 Changing to WISP mode
Note: You have to log in to the Web Configurator again when you change modes.As soon
as you do, your NBG4615 is already in WISP mode.
3 When you select WISP Mode, the following pop-up message window appears.
Figure 62 Pop up window for WISP mode
Click OK. The Web Configurator refreshes once the change to WISP mode is successful.
12.3.2 Accessing the Web Configurator in WISP Mode
To login to Web Configurator in WISP Mode, do the following:
1 Connect your computer to the LAN port of the NBG4615.