Filter
Top Products
Chapter 29 Maintenance
NBG4615 User’s Guide
222
Note: If you select the incorrect System Operation Mode you may not be able to connect
to the Internet.
Access Point Select Access Point Mode if your device bridges traffic between clients
on the same network.
•In Access Point Mode, all Ethernet ports have the same IP address.
• All ports on the rear panel of the device are LAN ports, including the
port labeled WAN. There is no WAN port.
• The DHCP server on your device is disabled.
• The IP address of the device on the local network is set to
192.168.1.2.
Universal Repeater Mode Select Universal Repeater Mode if you want to have wireless clients
associate with the NBG4615 and also want to connect the NBG4615 to an
existing access point.
• In addition to wireless LAN settings between the NBG4615 and
wireless clients, you also need to configure security and wireless
settings between the NBG4615 and another access point.
• WDS is not available when the NBG4615 is in Universal Repeater
Mode.
• The IP address of the device on the local network is the same as the IP
address given to the NBG4615 while in Access Point Mode (default is
192.168.1.2).
WISP Mode Select WISP Mode if your device needs a wireless client to connect to an
existing access point.
• You cannot configure Wireless LAN settings (including WPS) and
scheduling in the WISP Mode.
• The IP address of the device on the local network is the same as the IP
address given to the NBG4615 while in router mode (default is
192.168.1.1).
Apply Click Apply to save your settings.
Cancel Click Cancel to return your settings to the default (Router).
Table 90 Maintenance > Sys OP Mode (continued)
LABEL DESCRIPTION