Filter
Top Products
Chapter 17 WAN
NBG4615 User’s Guide
159
17.5 Advanced WAN Screen
Use this screen to enable Multicast and enable Auto-bridge.
Note: The categories shown in this screen are independent of each other.
IP Address Enter your WAN IP address in this field if you selected Use Fixed IP
Address.
IP Subnet Mask Your NBG4615 will automatically calculate the subnet mask based on the IP
address that you assign. Unless you are implementing subnetting, use the
subnet mask computed by the NBG4615.
Gateway IP
Address
Enter a Gateway IP Address (if your ISP gave you one) in this field.
WAN IP Address Assignment
Get automatically
from ISP
Select this to get your WAN IP address from your ISP.
Use Fixed IP Address Select this option If the ISP assigned a fixed IP address.
My WAN IP
Address
Enter your WAN IP address in this field if you selected Use Fixed IP
Address.
WAN DNS Assignment
First DNS Server
Second DNS Server
Select From ISP if your ISP dynamically assigns DNS server information
(and the NBG4615's WAN IP address). The field to the right displays the
(read-only) DNS server IP address that the ISP assigns.
Select User-Defined if you have the IP address of a DNS server. Enter the
DNS server's IP address in the field to the right. If you chose User-Defined,
but leave the IP address set to 0.0.0.0, User-Defined changes to None
after you click Apply. If you set a second choice to User-Defined, and
enter the same IP address, the second User-Defined changes to None
after you click Apply.
Select None if you do not want to configure DNS servers. If you do not
configure a DNS server, you must know the IP address of a computer in
order to access it.
WAN MAC Address The MAC address section allows users to configure the WAN port's MAC
address by either using the NBG4615’s MAC address, copying the MAC
address from a computer on your LAN or manually entering a MAC address.
Factory default Select Factory default to use the factory assigned default MAC Address.
Clone the computer’s
MAC address - IP
Address
Select Clone the computer's MAC address - IP Address and enter the IP
address of the computer on the LAN whose MAC you are cloning.
Set WAN MAC Address Select this option and enter the MAC address you want to use.
Apply Click Apply to save your changes back to the NBG4615.
Reset Click Reset to begin configuring this screen afresh.
Table 61 Network > WAN > Internet Connection: L2TP Encapsulation (continued)
LABEL DESCRIPTION