Filter
Top Products
Chapter 29 Maintenance
NBG4615 User’s Guide
214
The following table describes the labels in this screen.
29.4 Password Screen
It is strongly recommended that you change your NBG4615's password.
If you forget your NBG4615's password (or IP address), you will need to reset the device. See
Section 29.8 on page 219 for details.
Click Maintenance > Password. The screen appears as shown.
Figure 141 Maintenance > Password
The following table describes the labels in this screen.
Table 85 Maintenance > General
LABEL DESCRIPTION
System Setup
System Name System Name is a unique name to identify the NBG4615 in an Ethernet
network.
Domain Name Enter the domain name you want to give to the NBG4615.
Administrator
Inactivity Timer
Type how many minutes a management session can be left idle before the
session times out. The default is 5 minutes. After it times out you have to log in
with your password again. Very long idle timeouts may have security risks. A
value of "0" means a management session never times out, no matter how long
it has been left idle (not recommended).
Apply Click Apply to save your changes back to the NBG4615.
Cancel Click Cancel to begin configuring this screen afresh.
Table 86 Maintenance > Password
LABEL DESCRIPTION
Password Setup Change your NBG4615’s password (recommended) using the fields as shown.
Old Password Type the default password or the existing password you use to access the
system in this field.
New Password Type your new system password (up to 30 characters). Note that as you type
a password, the screen displays an asterisk (*) for each character you type.
Retype to Confirm Type the new password again in this field.
Apply Click Apply to save your changes back to the NBG4615.
Cancel Click Cancel to begin configuring this screen afresh.