Filter
Top Products
56 CHAPTER 4: INSTALLING DYNAMICACCESS SOFTWARE IN WINDOWS
The following table lists the minimum client requirements
and recommended Microsoft Service Packs (if any) for the
version of the DynamicAccess LAN agent that is included
on the EtherCD.
Installing the LAN Agent
To install the DynamicAccess LAN agent:
1 Make sure that the NIC and the network driver are
installed on your PC.
See Verifying Successful Installation on page 48 to confirm
that the NIC is properly installed in the computer.
2 Start Windows.
3 Insert the EtherCD in the CD-ROM drive.
The EtherCD Welcome screen appears.
4 Click NIC Software.
5 Click DynamicAccess Technology.
6 Click Install DynamicAccess Technology.
7 Select the appropriate menu option for your
operating system (Windows 95/98 or
Windows NT 4.0)
Operating
System
Requirements for Running
DynamicAccess Technology
on a Client PC
Recommended
Microsoft
Service Pack
Windows 2000 486/66 MHz CPU
32 MB RAM
5 MB available hard drive space
None required
Windows NT 4.0 Pentium/100 MHz CPU
32 MB RAM
5 MB available hard drive space
Service Pack 6
(or later)
Windows 98 486/76 MHz CPU
32 MB RAM
5 MB available hard drive space
Service Pack 1
Windows 95 486/76 MHz CPU
32 MB RAM
5 MB available hard drive space
Windows 95 OSR2 or
Service Pack 1
Ignore the Windows 2000 menu option. The
DynamicAccess LAN agent is not supported on a PC
running Windows 2000.