Filter
Top Products
80 CHAPTER 4: INSTALLING DYNAMICACCESS SOFTWARE IN WINDOWS
13 Verify that the displayed components are correct for
installation on your computer and click Next.
The system copies files from the EtherCD to the destination
location, sets up the registry, builds drivers, and updates
bindings.
The Winsock2 Setup screen appears.
Follow the rest of the setup wizard instructions to install
the software properly. If you see “version conflict”
messages, click Cancel to continue. When prompted to
reboot, click Yes (or OK or Next) to continue.
If you see “Winsock 2 setup” error messages, reboot the
system and re-start the 3Com LAN Encryption installation.
If prompted to insert the Windows CD, insert it so that
certain Windows files can be copied. (Prompting for the
Windows CD depends on your PC configuration.) Follow
the displayed prompts.
14 With the Winsock2 Setup screen displayed, click OK.
A warning message appears regarding the Dial-Up
Networking Upgrade.
15 Click OK.
The Microsoft Dial-Up Networking screen appears,
prompting you to restart.
16 Click Yes.
A message appears.
17 Click Yes.
A warning message appears, informing you that you must
restart and then manually run the installation process again.
18 Click OK.
The computer will restart.
19 Enter your network password when prompted.
The setup wizard continues to build drivers. The Insert Disk
screen appears, prompting you to insert the Windows 95
CD-ROM.