Filter
Top Products
227
Chapter 12
Power Over Ethernet Commands
The Power over Ethernet (PoE) commands are summarized in Table 22.
These commands are only supported on the PoE switches.
Table 22. Power over Ethernet Commands
Command Mode Description
“CLEAR POWER-INLINE
COUNTERS INTERFACE” on
page 229
Privileged Exec Clears the PoE event counters on the
ports.
“NO POWER-INLINE ALLOW-
LEGACY” on page 230
Port Interface Configures ports to deny power to
legacy powered devices (PDs).
“NO POWER-INLINE DESCRIPTION”
on page 231
Port Interface Deletes the PD descriptions.
“NO POWER-INLINE ENABLE” on
page 232
Port Interface Disables PoE on the ports.
“NO POWER-INLINE MAX” on
page 233
Port Interface Restores a port’s power limit to the
default value.
“NO POWER-INLINE PRIORITY” on
page 234
Port Interface Restores a port’s priority setting to the
default Low level.
“NO POWER-INLINE USAGE-
THRESHOLD” on page 235
Global
Configuration
Resets the power usage threshold to
the default 80%.
“NO SERVICE POWER-INLINE” on
page 236
Global
Configuration
Disables PoE on all of the ports on the
switch.
“NO SNMP-SERVER ENABLE TRAP
POWER-INLINE” on page 237
Global
Configuration
Disables the SNMP power-inline trap.
“POWER-INLINE ALLOW-LEGACY”
on page 238
Port Interface Configures a port to support legacy
PDs.
“POWER-INLINE DESCRIPTION” on
page 239
Port Interface Adds a PD description to a port.
“POWER-INLINE ENABLE” on
page 240
Port Interface Enables PoE on a port.
“POWER-INLINE MAX” on page 241 Port Interface Specifies the power limit of a port.