Filter
Top Products
CV7 Touch Panel Accessories
23
7" Modero Widescreen Touch Panels
7. Carefully peel-off one side of the included double-sided tape and adhere the adhesive side to the
surface of the antenna’s metal plate.
8. Grip the antenna by its sides and carefully peel-off the remaining protective film on the
double-sided tape.
9. Align the antenna atop the CF metal cover plate and press down firmly to securely adhere it.
10. To complete the upgrade process, close and resecure the panel enclosure using the procedures in the
following step.
Step 4: Close and Resecure the NXT Panel Enclosure
1.
In a single motion, gently slide the rear Tilt Bracket cover plate back over the tilt mechanism
(located below the LCD) and (while angling the housing downwards) slide the outer housing below
the Tilt Bracket and towards the LCD (at a downward angle).
2. Locate the two screw holes at either sides of the front speaker grill and then use a grounded
Phillips-head screwdriver to both insert and secure the two Tilt Bracket Screws (FIG. 17). This
procedure resecures the rear Tilt Bracket cover plate (with the AMX logo and Hinge brackets).
3. Press the outer housing forwards until it is aligned over the outer housing installation holes. Once
installed and secured, the tilt bracket prevents any further movement (FIG. 18).
4. Gently press down on the housing (toward the base) until it is securely positioned over the circuit
board and base.
5. While holding the circuit board cover in place, turn the panel back over until the LCD lies facedown
on a soft cloth and the under-side of the base is exposed.
6. Insert and secure the four Housing Screws (using a grounded Phillips-head screwdriver) in their
respective locations, as shown in FIG. 16 on page 20.
7. Replace any adhesive plastic "feet" that might have been removed during the removal process of the
outer housing. These "feet" must be placed back onto their original locations so they can fit into
their provided openings on the Battery Base.
8. Grasp both the LCD and housing and then rotate the entire unit back onto a flat surface.
9. Insert all connectors and apply power.
You must precisely align the double-sided tape to the surface of the antenna’s
metal plate in order to properly secure the antenna within to the CF metal cover
plate.
If the CF metal cover plate is not present over the wireless card slot, you can
use the adhesive tape to secure the terminal antenna to the surface of the new
card (atop the product label).