Filter
Top Products
CV7 Touch Panel Accessories
28
7" Modero Widescreen Touch Panels
Installing an NXT-BP into the NXA-BASE/1
The base does not directly connect to a power supply. Instead, it receives the power necessary to charge
the battery from the Modero panel (through the Panel Interface connector).
1. Install the NXT-BP battery into the base’s battery compartment with the label-side facing up.
2. Align the battery connector with its corresponding battery connector port (located in the battery
compartment shown in FIG. 27).
3. Carefully insert the NXT-BP into the base until the battery securely fits onto the Battery Connector
Port.
Installing the NXA-BASE/1 below an NXT-CV7 Panel
1.
Power Off the panel before attempting to attach the NXA-BASE/1.
2. Place the battery base (with battery) onto a flat/level surface.
3. Turn the battery locking slider (FIG. 28) to one side until the locking mechanism is horizontal to the
base (going left to right) and the rear battery latch is pointing directly outward (away from the
LCD).
FIG. 26 NXT-BP Battery Pack (showing the battery life indicator and button)
Battery Life Indicator button
Battery Life (Charge) Display
It is recommended to fully charge this battery before using it to power an NXT-CV7
panel. If the 25% LED indicator is blinking, recharge your battery immediately.
This blinking indicates there is less than 5% of a charge remaining on the battery.
FIG. 27 Battery installation
NXT-BP Battery
Battery
Connector
Battery
Connector
Port
FRONT