Filter
Top Products
Configuring Communication
66
7" Modero Widescreen Touch Panels
6. Press the Static WEP button to open the Static WEP Settings dialog (FIG. 64).
7. Enter the SSID information by either:
Automatically having it filled in by pressing the Site Survey button, navigating to the Site
Survey page, choosing a WEP secured WAP from within the Site Survey page, and then
pressing the Connect button.
Manually entering the SSID information into the appropriate field by following step 8.
8. Press the SSID field and from the Network Name (SSID) keyboard, enter the SSID name you are
using on your target Wireless Access Point (case sensitive), and press Done when finished.
The card should be given the SSID used by the target WAP. If this field is left blank, the unit
will attempt to connect to the first available WAP. By default, all WAP200Gs use AMX as
their assigned SSID value.
One of the most common problems associated with connection to a WAP arise because the
SSID was not entered properly. You must maintain the same case when entering this
information. ABC is not the same as Abc.
FIG. 63 Wireless Settings page (showing how each card supports its own security features)
802.11b wireless card 802.11g wireless card
You must first take down the SSID name, Current Key string value, and panel MAC
Address information so you can later enter it into the appropriate WAP dialog fields in
order to "sync-up" the secure connection. These values must be identically
reproduced on the target WAP.
FIG. 64 Wireless Settings page - Static WEP security method
Required Information:
- SSID (Network Name used by the Target WAP)
- Encryption Method
- Passphrase
- WEP Key assignment
- Authentication Method