Filter
Top Products
iMac (24-inch Mid 2007) Take Apart — LCD Display Panel 80
Replacing the Display Panel
Connect the LVDS cable to the rear of the display panel.1.
Connect the inverter cable to the inverter board on the rear of the display panel. Replace the 2.
black mylar tape over the inverter cable connector.
Make sure the other end of the inverter cable is connected to the power supply.3.
Make sure the display temp sensor and the temp sensor cable are connected at the top of 4.
the display panel and that the foam gasket is covering the sensor.
Lower the LCD panel into the computer assembly.5.
6. Connect the LVDS cable to the logic board. Replace the two T6 screws.
922-7010