Filter
Top Products
B-6 VS1MD User Manual
B.2.6 Installation
B.2.6.1 VS1MD-NM1A, VS1MD-NM1B, VS1MD-NM1C
Preparation:
Step 1. Remove input power from drive and wait 10 minutes before proceeding.
Step 2. Remove cover from drive exposing the terminal strips.
Step 3. Remove two screws from ground connection bar inside drive to the left of
the power terminals. Retain screws.
Step 4. Remove two screws and cover from front of conduit kit. Retain screws.
Installation (refer to legends in diagram):
Step 1. Snap top vent cover onto the top of the drive, ensuring that all four tabs
correctly engage their respective openings in the drive vent holes.
Step 2. Place the conduit kit, less the cover, such that the lower left tab with the
two holes is over the ground connection bar holes and the top right tab is
inserted in the provided slot, near the bottom right of the drive.
!
!
WARNING: Do not touch any circuit board, power device or electrical
connection before you first ensure that power has been disconnected and
there is no high voltage present from this equipment or other equipment to
which it is connected. Electrical shock can cause serious or fatal injury.
Only qualified personnel should attempt the start-up procedure or
troubleshoot this equipment.
!
!
WARNING: Do not remove cover for at least ten (10) minutes after AC
power is disconnected to allow capacitors to discharge. Dangerous
voltages are present inside the equipment. Electrical shock can cause
serious or fatal injury.