Filter
Top Products
Using the Keypad 6-7
The first parameter of each group, with the exception of the “Display Group”, is a
special parameter called a “Jump Code”. The parameter can be used to jump to a
specific parameter within a group without having to scroll through the parameters
using the up and down arrows. Once the Jump Code is programmed, the drive will
save the setting for future use, but this can always be reprogrammed to jump to a
different parameter.
The following example illustrates the use of a Jump Code to jump to parameter P38.
Table 6.6 – Using the Jump Code
Procedure Sample Display
Step 1. From the operation mode, press and hold down the
ENTER key for at least two seconds to change the
drive to the programming mode. The “PROG” LED
will illuminate indicating that the drive is in
programming mode. The drive will display the first
parameter of the “Display” group.
Step 2. Press the right arrow to change to the “Parameters”
group.
Step 3. Press the ENTER key to edit P0 (Jump Code).
Step 4. Press the UP arrow seven times until the display
indicates an “8”.
Step 5. Press the left arrow one time such that the next digit
is displayed. It will be displayed brighter than the
previous digit.
Step 6. Press the UP arrow three times such that the display
indicates the parameter number.
Step 7. Press the ENTER key to accept the value. The value
will be saved in the Jump Code (P0) for future use
and the desired parameter will immediately be
displayed.