Filter
Top Products
Using the Keypad 6-5
You can only move between groups while the first parameter of the group is displayed.
Pressing the left or right arrow while displaying any parameter other than the first
parameter of the group returns to the first parameter of the group.
Step 5. Press the right arrow key to change to “Function
Group 1”.
Step 6. Press the right arrow key to change to “Function
Group 2”.
Step 7. Press the right arrow key to change to “Display”
group.
Step 8. Press and hold down the ENTER key for at least two
seconds to change the drive from the programming
mode back to operation mode.The “PROG” LED will
go out indicating that the drive is in operation mode.
The drive will display the default “Power On Display”.
Note that the above can be execute in reverse order by using the left arrow key
instead of the right arrow key.
Table 6.3 – Moving Between Parameter Groups
Procedure Sample Display
Function Group 1
Function Group 2
Terminal group
Pressing the
left or right
arrow from
any parameter
returns you to
the first
parameter of
the group
Pressing the
up or down
arrow moves
you within a
group of
parameters