Filter
Top Products
6-8 VS1MD AC Drive User Manual
The following example shows how to use a previously stored Jump Code.
6.8 Modifying the Value of a Parameter
The parameters located in the Display group are read-only and can not be modified.
All other parameters (with a few exceptions) can be modified by the user. Some
parameters are configurable - meaning that the drive must be stopped before the
parameter can be modified, while others are tunable - meaning that the parameter can
be modified while the drive is stopped or running.
Table 6.7 – Using a Previously Stored Jump Code
Procedure Sample Display
Step 1. From the operation mode, press and hold down the
ENTER key for at least two seconds to change the
drive to the programming mode. The “PROG” LED
will illuminate indicating that the drive is in
programming mode. The drive will display the first
parameter of the “Display” group.
Step 2. Press the right arrow to change to the “Parameters”
group.
Step 3. Press the ENTER key to access the Jump Code.
Step 4. Press the ENTER key a second time and the desired
parameter will be displayed.