Filter
Top Products
Accessories
A-8
Falcon
®
4400 Series with Windows
®
CE
Installing the Handle or Handstrap
The Falcon 4420 comes from the factory with the handle installed. The Falcon
4410 comes with a handstrap. These can be exchanged with a change-out kit.
The handle is removable and can be replaced with a handstrap. When you
replace the handle with the handstrap, you lose the ability to press the trigger
on the handle and must use the
<Scan> key on the Falcon keypad instead.
To remove the handle and replace it with the handstrap refer to the following
sections. Reverse the same directions to replace the handstrap with the handle.
Installing the Handstrap on the Falcon 4420
To install a handstrap on the Falcon 4420, complete the following steps:
1. Remove the handle as shown in Figure A-11 by removing the screws
located just above the battery cover’s latch dials.
2. Insert the top tab of the handstrap cover into the slot at the top of the
handle recess. (refer to Figure A-10)
Figure A-10. Removing/Replacing a Handstrap
Cover
Plate
Retaining
Pin
Retaining Pin
is threaded
through loop
in strap and
seated in sockets
Handstrap
Handstrap
PDT
Cover
Plate