Filter
Top Products
Configuring System Information 139
•
IPv6 Address Origin Type
— Defines the type of configurable static IPv6 address for an interface.
The possible values are:
– Dyanmic
— Indicates the IP address was received from RA.
–
Static
— Indicates the IP address was configured by the user.
–
System
— Indicates the IP address was generated by the system.
•
DAD Status
— Displays the Duplicate Address Detection (DAD) Status which is the process of
verifying and assuring an inserted IPv6 address is unique. This is a read-only parameter with the
following field values:
–
Tentative
— Indicates the system is in process of IPv6 address duplication verification.
–
Duplicate
— Indicates the IPv6 address is being used by an another host on the network.
The duplicated IPv6 address is suspended and is not used for sending or receiving any traffic.
–
Active
— Indicates the IPv6 address is set to active.
•
Remove
— When selected, removes the address from the table.
Adding an IPv6 Interface
1
Open the
IPv6 Interface
page.
2
Click
Add IPv6 Interface
.
The
Add a Static IPv4 Interface
page opens.
Figure 6-34. Add IPv6 Interface
3
Complete the fields on the page.
IPv6 Interface
specifies whether the interface is a specific port, LAG or VLAN.
4
Click
Apply Changes
.
The new interface is added, and the device is updated.