Filter
Top Products
Configuring Switch Information 361
Displaying the VLAN LAG Table
1
Open the
VLAN LAG Settings
page.
2
Click
Show All
.
The
VLAN LAG Table
opens.
Figure 7-51. VLAN LAG Table
3
To change LAG settings, modify the fields for any LAGs in the table.
4
Click
Apply Changes
.
The VLAN LAG parameters are defined, and the device is updated.
Assigning LAGs to VLAN Groups Using CLI Commands
The following table summarizes the equivalent CLI commands for assigning LAGs to VLAN groups as
displayed in the VLAN LAG Settings page.
Table 7-28. LAG VLAN Assignments CLI Commands
CLI Command Description
switchport mode {access | trunk | general
} Configures a LAG VLAN membership mode.
switchport trunk native vlan vlan-id Defines the port as a member of the specified VLAN, and the
VLAN ID as the LAG default VLAN ID (PVID).
switchport general pvid vlan-id Configure the LAG VLAN ID (PVID) when the interface is in
general mode.
switchport general allowed vlan add
vlan-list
[
tagged | untagged]
Adds or removes VLANs from a general LAG.
switchport general acceptable-frame-type
tagged-only
Discards untagged packets at ingress.
switchport access vlan dynamic Binds the MAC address to the VLAN.
switchport general ingress-filtering disable Disables LAG ingress filtering.