Filter
Top Products
Configuring Switch Information 311
4
Check the
Copy to
check box to define the interfaces to which the storm control definitions are
copied, or click
Select All
to copy the definitions to all ports.
5
Click
Apply Changes
.
The parameters are copied to the selected ports in the
Storm Control Settings Table
, and the device is
updated.
Configuring Storm Control with CLI Commands
The following table summarizes the equivalent CLI commands for configuring Storm Control as
displayed on the Storm Control page.
The following is an example of the CLI commands:
Table 7-14. Storm Control CLI Commands
CLI Command Description
port storm-control include-multicast
Enables the device to count Multicast,
Unicast, and Broadcast packets together.
port storm-control broadcast enable
Enables broadcast storm control.
port storm-control broadcast rate
Configures the maximum broadcast rate.
show ports storm-control
port
Displays the storm control configuration.
console(config)# port storm-control include-multicast
console(config)# interface ethernet 1/e1
console(config-if)# port storm-control broadcast enable
console(config-if)# port storm-control broadcast rate 100000
console(config-if)# end
console# show ports storm-control
Port Broadcast Storm control [kbyes/sec]
----- -------------------------------------
1/e1 8000
2/e1 Disabled
3/e2 Disabled