Filter
Top Products
160 Configuring System Information
When defining a new host name mapping, the following additional parameters are available:
•
Supported IP Format
— Specifies the IP format supported by the host. The possible values are:
–
IPv6
— IP version 6 is supported.
–
IPv4
— IP version 4 is supported.
•
IPv6 Address Type
— When the host supports IPv6 (see previous parameter), this specifies the type of
static address supported. The possible values are:
–
Link Local
— A Link Local address that is non-routable and used for communication on the same
network only.
–
Global
— A globally unique IPv6 address; visible and reachable from different subnets.
•
Link Local Interface
— When the server supports an IPv6 Link Local address (see previous
parameter), this specifies the the Link Local interface. The possible values are:
–
VLAN1
— The IPv6 interface is configured on VLAN1.
–
ISATAP
— The IPv6 interface is configured on ISATAP tunnel.
Adding Host Domain Names
1
Open the
Host Name Mapping
page
.
2
Click
Add
.
The
Add Host Name Mapping
page opens.
Figure 6-48. Add Host Name Mapping
3
Define the relevant fields.
4
Click
Apply Changes
.
The IP address is mapped to the Host Name, and the device is updated.