Filter
Top Products
322 Configuring Switch Information
Defining GARP Timers
The GARP Timers page contains fields for enabling GARP on the device.
To open the GARP Timers page, click Switch → GARP → GARP Timers in the tree view.
Figure 7-33. GARP Timers
The GARP Timers page contains the following fields:
•
Interface
— Determines if enabled on a port or on a LAG..
•
GARP Join Timer (10 - 2147483640)
— Time, in milliseconds, that Protocol Data Units (PDU) are
transmitted. The default value is 200 msec.
•
GARP Leave Timer (10 - 2147483640
) — Time lapse, in milliseconds, that the device waits before
leaving its GARP state. Leave time is activated by a Leave All Time message sent/received, and
cancelled by the Join message received. Leave time must be greater than or equal to three times the
join time. The default value is 600 msec.
•
GARP Leave All Timer (10 - 2147483640)
— Time lapse, in milliseconds, that all devices wait before
leaving the GARP state. The leave all time must be greater than the leave time
.
The default value is
10000 msec.
Defining GARP Timers
1
Open the
GARP Timers
page.
2
Select an interface.
3
Complete the fields.
4
Click
Apply Changes
.
The GARP parameters are saved to the device.