Filter
Top Products
202 Configuring System Information
•
Dead Time (0-2000)
— Indicates the amount of time (in minutes) that a RADIUS server is bypassed
for service requests. The range is 0-2000.
•
Key String (0-128 Characters)
— The Key string used for authenticating and encrypting all RADIUS
communications between the device and the RADIUS server. This key is encrypted.
•
Source IP Address
— Indicates the source IP address that is used for communication with RADIUS
servers.
•
Usage Type
—
Indicates the server usage type. Can be one of the following values: login, 802.1x or
all. If unspecified, defaults to all.
•
Use Default
— Uses the default value for the parameter.
If host-specific Timeouts, Retries, or Dead time values are not specified, the Global values (Defaults) are
applied to each host. The following fields set the RADIUS default values:
•
Default Retries (1-10)
— Indicates the default number of transmitted requests sent to RADIUS server
before a failure occurs.
•
Default Timeout for Reply (1-30)
— Indicates the default amount of the time (in seconds) the device
waits for an answer from the RADIUS server before timing out. The default is 5 seconds.
•
Default Dead time (0-2000)
— Indicates the default amount of time (in minutes) that a RADIUS
server is bypassed for service requests. The range is 0-2000.
•
Default Key String (0-128 Characters)
— The Default Key string used for authenticating and
encrypting all RADIUS communications between the device and the RADIUS server. This key
is encrypted.
•
Source IPv4 Address
— Specifies the source IP version 4 address that is used for communication with
RADIUS servers.
•
Source IPv6 Address
— Specifies the source IP version 6 address that is used for communication with
RADIUS servers.
When adding a new RADIUS server, the following additional parameter is available:
•
Supported IP Format
— Specifies the IP format supported by the server. The possible values are:
–
IPv6
Global — IP version 6 is supported.
–
IPv4
— IP version 4 is supported.
Defining RADIUS Parameters:
1
Open the
RADIUS Settings
page.
2
Define the fields.
3
Click
Apply Changes
.
The RADIUS setting are updated to the device.