Filter
Top Products
208 Configuring System Information
Configuring LLDP Using CLI Commands
The following is an example of the CLI commands:
Defining LLDP Port Settings
The LLDP Port Settings page allows network administrators to define LLDP port settings, including the
port number, the LLDP port number, and the type of port information advertised.
The Port Settings page contains fields for configuring LLDP. To open the Port Settings page,
click System
→ LLDP-MED → Port Settings in the tree view.
Table 6-43. LLDP Properties CLI Commands
CLI Command Description
lldp enable (global)
Enables enable Link Layer Discovery Protocol.
lldp hold-multiplier
number
Specifies the time that the receiving device should
hold a Link Layer Discovery Protocol (LLDP) packet
before discarding it.
lldp reinit-delay
Seconds
Specifies the minimum time an LLDP port will wait
before reinitializing.
lldp tx-delay
Seconds
Specifies the delay between successive LLDP frame
tr.ansmissions.
Console(config)# interface ethernet g1
Console(config-if)# lldp enable