Filter
Top Products
254 Configuring System Information
The Active Images page contains the following fields:
•
Unit No.
— The unit number for which the Image file is selected.
•
Active Image
— The Image file which is currently active on the unit.
•
After Reset
— The Image file which is active on the unit after the device is reset. The possible field
values are:
–
Image 1
— Activates Image file 1 after the device is reset.
–
Image 2
— Activates Image file 2 after the device is reset.
Selecting an Image File
1 Open the
Active Images
page
.
2 Select an Image file for a specific unit in the After Reset field.
3 Click Apply Changes.
The Image file is selected. The Image file reloads only after the next reset. The currently selected
Image file continue to run until the next device reset.
Working with the Active Image File Using CLI Commands
The following table summarizes the equivalent CLI commands for viewing fields displayed in the Active
Images.
The following is an example of the CLI commands:
Table 6-55. File Upload CLI Commands
CLI Command Description
boot system [unit | unit ]
{image-1 | image-2}
Indicates the system image that the device loads
at startup.
show version [unit unit] Displays version information for the system
Console# boot system image-1