Filter
Top Products
446 Configuring Quality of Service
Assigning QoS Interfaces Using the CLI Commands
The following table summarizes the equivalent CLI commands for configuring fields in the Interface
Settings page.
The following is an example of the CLI commands:
Defining Bandwidth Settings
The Bandwidth Settings page contains fields for defining the bandwidth settings for a specified egress
interface. Modifying queue scheduling affects the queue settings globally. Queue shaping can be based
per queue and/or per interface. Shaping is determined by the lower specified value. The queue shaping
type is selected in the Bandwidth Settings Page, click Quality of Service → CoS Global Parameters→
Bandwidth Settings in the tree view.
Figure 9-3. Bandwidth Settings
Table 9-4. QoS Interface CLI Commands
CLI Command Description
qos trust Enables the trust mode.
no qos trust Disables Trust state on each port.
console(config)# interface ethernet 1/e15
console(config-if)# qos trust