Filter
Top Products
Configuring Switch Information 303
The following is an example of the CLI commands:
console(config)# interface ethernet 1/e3
console(config-if)# description "RD SW#3"
console(config-if)# shutdown
console(config-if)# no shutdown
console(config-if)# speed 100
console(config-if)# duplex full
console(config-if)# negotiation
console(config-if)# back-pressure
console(config-if)# flowcontrol on
console(config-if)# mdix auto
console(config-if)# end
console# show interfaces configuration ethernet 1/e3
Port Type Duplex Speed Neg Flow
Control
Admin
State
Back
Pressure
Mdix
Mode
---- ----- ------ ------ ---- ------ ----- ------ ----
1/e3 100 Full 100 Enabled On Up Enable Auto
Console# show interfaces status
Port Type Duplex Speed Neg Flow
Control
Link
State
Back
Pressure
Mdix
Mode
---- ----- ------ ------ ---- ------ ----- ------ ----
1/e3 100 Full 100 Auto On Up Enable On
1/e4 100 Full 1000 Off Off Up Disable On
Ch Type Duplex Speed Neg Flow
Control
Back
Pressure
Link
State
--- ---- ------ ----- ----- ------- -------- ------
Ch1 1000 Full 1000 Off Off Disable Up