Filter
Top Products
Configuring System Information 237
Deleting Communities
1
Open the
SNMP Community
page.
2
Click
Show All
.
The
Community Table
page opens.
Figure 6-99. Community Table
3
Select a community and check the
Remove
check box.
4
Click
Apply Changes
.
The community entry is deleted, and the device is updated.
Configuring Communities Using CLI Commands
The following table summarizes the equivalent CLI commands for viewing fields displayed in the SNMP
Community.
The following is an example of the CLI commands:
Table 6-50. SNMP Community CLI Commands
CLI Command Description
snmp-server community community [ro | rw |
su] [ipv4-address | ipv6-address][view view-
name]
Sets up the community access string to permit access to the
SNMP protocol.
snmp-server community-group community
group-name [ipv4-address | ipv6-address]
Sets up community access string to permit limited access to the
SNMP protocol based on group access rights.
show snmp Displays the current SNMP device configuration.
Console (config)# snmp-server community dell ro 10.1.1.1