Filter
Top Products
System Management: Vendor Commands
ATCA-9305 User’s Manual 10009109-01
7-24
VENDOR COMMANDS
The IPMC supports additional IPMI commands that are specific to Pigeon Point and/or
Emerson. This section provides detailed descriptions of those extension or SIPL commands.
Table 7-16: Vendor Command Summary
Response Data 9 Override State Color
Bits [7:4] reserved, set to 0
Bits [3:0]
0h reserved
1h Blue
2h Red
3h Green
4h Amber
5h Orange
6h White
7h-Fh reserved
10 Lamp Test Duration—is optional if Lamp Test is not in effect
(hundreds of milliseconds).
Command: netFn: LUN: Cmd:
Get Status OEM 2E, 2F 00
Get Serial Interface Properties OEM 2E, 2F 01
Set Serial Interface Properties OEM 2E, 2F 02
Get Debug Level OEM 2E, 2F 03
Set Debug Level OEM 2E, 2F 04
Get Hardware Address OEM 2E, 2F 05
Set Hardware Address OEM 2E, 2F 06
Get Handle Switch OEM 2E, 2F 07
Set Handle Switch OEM 2E, 2F 08
Get Payload Communication Time-Out OEM 2E, 2F 09
Set Payload Communication Time-Out OEM 2E, 2F 0A
Enable Payload Control OEM 2E, 2F 0B
Disable Payload Control OEM 2E, 2F 0C
Reset IPMC OEM 2E, 2F 0D
Hang IPMC OEM 2E, 2F 0E
Bused Resource Control OEM 2E, 2F 0F
Bused Resource Status OEM 2E, 2F 10
Graceful Reset OEM 2E, 2F 11
Diagnostic Interrupt Results OEM 2E, 2F 12
Get Payload Shutdown Time-Out OEM 2E, 2F 15
Set Payload Shutdown Time-Out OEM 2E, 2F 16
Type: Byte: Data Field: (continued)