Filter
Top Products
System Management: Vendor Commands
ATCA-9305 User’s Manual 10009109-01
7-30
Get Hardware Address
The Get Hardware Address command reads the hardware address of the IPMC.
Table 7-22: Get Hardware Address Command
Set Hardware Address
The Set Hardware Address command allows overriding of the hardware address read from
hardware when the IPMC operates in (Manual) Standalone mode.
Table 7-23: Set Hardware Address Command
Request Data 4 Bits [7:5] reserved
Bit [4] IPMB Dump Enable
If set to 1, the IPMC provides a trace of IPMB messages that are
arriving to/going from the IPMC via IPMB-0 or IPMB-L
Bit [3] Payload Logging Enable
If set to 1, the IPMC provides a trace of SIPL activity on the
Payload interface onto the Serial Debug interface
Bit [2] Alert Logging Enable
If set to 1, the IPMC outputs important alert messages onto the
Serial Debug interface
Bit [1] Low-level Error Logging Enable
If set to 1, the IPMC outputs low-level error/diagnostic
messages onto the Serial Debug interface
Bit [0] Error Logging Enable
If set to 1, the IPMC outputs error/diagnostic messages onto the
Serial Debug interface
Response Data 1 Completion Code
2:4 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
Type: Byte: Data Field:
Request Data 1:3 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
Response Data 1 Completion Code
2:4 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
5 Hardware Address
Type: Byte: Data Field:
Request Data 1:3 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
Type: Byte: Data Field: (continued)