Filter
Top Products
Management Processor Monitor: IPMC Commands
10009109-01 ATCA-9305 User’s Manual
9-17
iprobe
The iprobe command probes to discover valid primary I
2
C bus chip addresses.
Definition:
iprobe
IPMC COMMANDS
IPMI Baseboard Management Controller (BMC) watchdog is supported and serviced
throughout the monitor boot process. The BMC watchdog is disabled if the monitor goes to
the monitor prompt.
bootdev
The bootdev command gets or sets the initial boot bank. Get prints out the flash bank set as
initial boot device.
Definition:
bootdev get
The IPMC sets the hardware strapping for the initial boot device.
bootdev set <bank>
Where <bank> is either b0 or b1 for the corresponding flash bank, or b3 to boot from socket
and if a shunt is installed on J9 [1:2].
fru
The fru command opens, closes, saves, sets, shows, dumps, and loads fru data to and from
the IPMC.
Definition:
fru <command> [ arg1 arg2 … ]
command := [ open | close | save | set | show | dump | load | create ]
fru open <id>
fru close
fru save
fru set <section [chassis|board|product]><field><value>
fru set <section> <field> <value>
section := [ chassis | board | product ]
fru set chassis <field> <value>
field := [ type | part | serial ]
fru set board <field> <value>
field := [ date | maker | name | serial | part | file ]
fru set product <field> <value>
field := [ maker | name | part | version |serial | asset | file ]
fru show
fru dump <address>
fru load <address><size>
Set data in the internal use area.