Filter
Top Products
10009109-01 ATCA-9305 User’s Manual
9-1
Section 9
Management Processor Monitor
The ATCA-9305 monitor is based on the Embedded PowerPC Linux Universal Boot (U-Boot)
Project program, available under the GNU General Public License (GPL). For instructions on
how to obtain the source code for this GPL program, please visit http://www.emersonem-
beddedcomputing.com/post-sales_support/218, send an e-mail to support@arte-
syncp.com, or call Emerson at (800) 327-1251.
This chapter describes the monitor’s basic features, operation, and configuration
sequences. This chapter also serves as a reference for the monitor commands and func-
tions.
COMMAND-LINE FEATURES
The ATCA-9305 monitor uses a command-line interface with the following features:
Auto-Repeat: After entering a command, you can re-execute it simply by pressing the ENTER or RETURN
key.
Command History: Recall previously entered commands using the up and down arrow keys.
TFTP Boot: You can use the TFTP protocol to load application images via Ethernet into the ATCA-9305’s
memory.
Auto-Boot: You can store specific boot commands in the environment to be executed automatically
after reset.
Flash Programming: You can write application images into flash via the U-Boot command line. The upper 1 MB at
the base of flash and 128 KB of each flash bank is reserved for the monitor and environment
variables (see “MPC8548 Memory Map”). One megabyte is reserved at the second bank of
flash. The moninit command will load both banks of flash (see “moninit” on page 9-22) with
the monitor and default environment variables.
At power-up or after a reset, the monitor runs diagnostics and reports the results in the
start-up display, see
Fig. 9-1. During the power-up sequence, the monitor configures the
board according to the environment variables (see “MPC8548 Environment Variables” on
page 9-26). If the configuration indicates that autoboot is enabled, the monitor attempts to
load the application from the specified device. If the monitor is not configured for autoboot
or a failure occurs during power-up, the monitor enters normal command-line mode. Also,
the optional “e-keying” environment variable enables connections at power-up, for debug
purposes only, to the Update Channel and payload ports that go off the ATCA-9305. See
Ta bl e 9 - 7 for more information.
The monitor command prompt in
Fig.9-1 is the result of a successful hardware boot of the
ATCA-9305.