Filter
Top Products
Setup: Troubleshooting
10009109-01 ATCA-9305 User’s Manual
2-11
Insert a board:
1 Insert the ATCA-9305 into an available slot.
2 Push in the front panel handle (tab).
The blue Hot Swap LED on the front panel (see
Fig.2-1) flashes a long blink to indicate that
board insertion is in progress and system management software is activating the slot. Then
the blue LED turns off, indicating the insertion process is complete, and payload power is
present.
Remove a board:
1 Pull out the handle (tab) on the ATCA-9305 front panel one click.
A short blink indicates the board is requesting permission for extraction.
2 Remove the board when the blue LED on the front panel is on (no payload power).
Caution: Do not remove the ATCA-9305 while the blue LED is blinking.
TROUBLESHOOTING
In case of difficulty, use the following checklist:
Be sure the ATCA-9305 circuit board is seated firmly in the carrier.
Be sure the system is not overheating.
Check the cables and connectors to be certain they are secure.
Check that your terminal is connected to a console port.
Technical Support
If you need help resolving a problem with your ATCA-9305, visit
http://www.emersonembeddedcomputing.com/ on the internet or send E-mail to sup-
port@artesyncp.com. Please have the following information handy:
• ATCA-9305 serial number and product identification (see
Fig.2-8)
• MPC8548 monitor version number (see
Fig. 9-1)
• Cavium monitor version number (see
Fig. 3-3)
• version and part number of the operating system (if applicable)
!