Filter
Top Products
8-2 C122-E003-02EN
GSWB
CHAPTER 8 CLI Operations
Note: The above prompts are examples where the host name is "Switch".
After login to the GSWB, a transition to either of the command modes of the
operation commands depends on the user privilege, as shown in the following table.
Table 8.2 User privileges and command modes
After a transition to enabled exec, the configure command can be used for a transition
of a command mode of the configuration definition commands or the editing
commands.
Configuration
definition commands
Global configuration Switch (config)# Mode for configuring
settings for the whole
device
Interface
configuration
Switch (config-if)# Mode for configuring
interface settings
Line configuration Switch (config-line)# Mode for configuring
terminal line settings
VLAN configuration Switch (config-vlan)# Mode for configuring
VLAN settings
Editing commands Global edit Switch (edit)# Mode for editing all
device items
Interface edit Switch (edit-if)# Mode for globally
editing all interface
items
Line edit Switch (edit-line)# Mode for editing
terminal line items
VLAN edit Switch (edit-vlan)# Mode for editing
VLAN items
No. User privilege
Operation command mode
transition destination
1 LDAP user privilege user user exec
2 LDAP admin privilege user enabled exec
Command type Command mode Prompt Description