Filter
Top Products
C122-E003-02EN 8-71
GSWB
8.2 Configuration Definition Commands
• Input parameter error.
Cause: An invalid parameter was specified.
Action: Specify the correct parameter.
8.2.9.3 switchport mode
This command is used to select the VLAN membership mode of an interface.
The available VLAN commands vary depending on the selected mode. No specific
error message is displayed, however, after execution of a mode-dependent command
that cannot be executed.
z Commands that can be executed in Access mode
switchport access vlan
z Commands that can be executed in Trunk mode
switchport allowed vlan
switchport native vlan
When making this setting for a port-channel port, no setting is required for a physical
link that is part of the target port-channel. The contents of settings made for such
links are not reflected. The setting for a physical link in the port-channel is reflected
in the physical link at the time the link is removed from the port-channel.
(1) Synopsis
• Sets the selected VLAN membership mode for an interface
• Resets the VLAN membership mode to the initial setting (access)
(2) Options
z {access | trunk}
- access: Makes the interface function as a port VLAN (default).
- trunk: Sets up a VLAN trunk (tagged VLAN).
(3) Command mode
Interface
switchport mode {access | trunk}
no switchport mode