Filter
Top Products
C122-E003-02EN 8-137
GSWB
8.2 Configuration Definition Commands
(6) Error Messages
• % Incomplete command.
Cause: Incomplete command input
Action: Enter the command string correctly.
• % Invalid input detected at '^' marker.
Cause: Invalid character detected at '^' marker in the entered command string
Action: Enter the command string correctly.
• Internal communication error.
Cause: An internal error occurred.
Action: Check the system status, and reenter the command. If the error occurs again,
collect unit information, configuration definition information, and the
information in different types of logs, and restart the unit. Alternatively,
contact a certified service engineer.
• Input parameter error.
Cause: An invalid IP address was specified.
Action: Enter the correct IP address.
• Input parameter duplicate error.
Cause: Duplicated registration of the same ntp server was attempted.
Action: Check the ntp servers already registered.
• Set count over.
Cause: Registration of 4 or more ntp servers was attempted.
Action: Check the ntp servers already registered.
• Entry isn’t existed.
Cause: Deletion of an unregistered ntp server was attempted.
Action: Check the ntp servers already registered.
8.2.21.2 ntp status
This command sets the interval of inquiries to an NTP server.
If multiple NTP servers are registered, the setting is made for all of the NTP servers.
Clock time adjustments make take up to six minutes.