Filter
Top Products
MAGNUM 6K SWITCHES, MNS-6K USER GUIDE
16 Enabled 19531 0 NO
Magnum6K25(device)## rate-threshold port=11 rate=3500
Broadcast Rate Threshold set
Magnum6K25(device)## show broadcast-protect
======================================================================
PORT | STATUS | THRESHOLD (frms/sec) | CURR RATE (frms/sec) | ACTIVE
======================================================================
9 Enabled 19531 0 NO
10 Enabled 19531 0 NO
11 Enabled 3500 0 NO
12 Enabled 19531 0 NO
13 Enabled 19531 0 NO
14 Enabled 19531 0 NO
15 Enabled 19531 0 NO
16 Enabled 19531 0 NO
FIGURE 66 – Setting up broadcast storm protection. Also shows how the threshold can be lowered for a
specific port
Port Rate limiting for broadcast
traffic
Please refer to the above section on broadcast storms.
List of commands in this chapter
Syntax show port-mirror – display port mirror settings
Syntax port-mirror <enter> - configure port mirror settings
Syntax setport monitor=<monitor port number> sniffer=<sniffer port number> - set port
mirror settings
Syntax prtmr <enable|disable> - enable or disable port mirror settings
Syntax device – configure device and port specific settings
Syntax
setport port=<port#|list|range> [name=<name>] [speed=<10|100>]
[duplex=<half|full>] [auto=<enable|disable>] [flow=<enable|disable>]
[bp=<enable|disable>] [status=<enable|disable>] – configure port settings
Syntax show port[=<Port number>] – display port settings
Syntax flowcontrol xonlimit=<value> xofflimit=<value> - configure flow control buffers
101