Filter
Top Products
UPDATING SOFTWARE – STEP 3
Upgrade is Successful. Please reboot Magnum 6Kxx to start the application
Magnum6K25# reboot
Proceed on rebooting the switch? [ 'Y' or 'N' ] Y
Do you wish to save current configuration? [ 'Y' or 'N' ] Y
(The switch will now reboot. After the reboot, the Magnum 6K switch may prompt you should the
boot code need an update. If prompted, say “Y” to update the boot code. After the reboot and
login verify the MNS-6K software was upgraded.)
Magnum6K25# show version
MNS-6K Ver: 3.4 Date:Mar 31 2006 Time:17:06:23 Build ID 1143853580
FIGURE 155 – upgrading the switch using the serial interface
Network Access
Prerequisites - make sure the directory and the file name of the MNS-6K software image
downloaded in steps 1 and 2 is known. To upgrade using TFTP or FTP, ensure that the
FTP or TFTP server is set up and the switch can ‘ping’ the TFTP or the FTP server and
vice-versa. Ensure that the server has access to the MNS-6K software image downloaded in
step 2. Make sure the MNS-6K software image file is copied to the default folder specified
by the FTP or TFTP server. If using FTP services, make sure the FTP access information
(login name and password) is also known.
In the example below, let us assume that the IP address of the TFTP server is
192.168.10.99; that the server can ping the switch and the switch can ping the server.
Intentionally left blank for image continuity – image shown on next page
316