Filter
Top Products
MAGNUM 6K SWITCHES, MNS-6K USER GUIDE
• RMON MIB (RFC 1757)
• RMON: groups 1, 2, 3, and 9 (Statistics, Events, Alarms, and History)
• Version 1 traps (Warm Start, Cold Start, Link Up, Link Down, Authentication Failure,
Rising Alarm, Falling Alarm)
RFC 1901-1908 – SNMPv2
• RFC 1901, Introduction to Community-Based SNMPv2. SNMPv2 Working Group
• RFC 1902, Structure of Management Information for Version 2 of the Simple Network
Management Protocol (SNMPv2). SNMPv2 Working Group
• RFC 1903, Textual Conventions for Version 2 of the Simple Network Management
Protocol (SNMPv2). SNMPv2 Working Group
• RFC 1904, Conformance Statements for Version 2 of the Simple Network Management
Protocol (SNMPv2). SNMPv2 Working Group
• RFC 1905, Protocol Operations for Version 2 of the Simple Network Management
Protocol (SNMPv2). SNMPv2 Working Group
• RFC 1906, Transport Mappings for Version 2 of the Simple Network Management
Protocol (SNMPv2)
• RFC 1907, Management Information Base for Version 2 of the Simple Network
Management Protocol (SNMPv2). SNMPv2 Working Group
• RFC 1908, Coexistence between Version 1 and Version 2 of the Internet-standard
Network Management Framework. SNMPv2 Working Group
RFC 2271-2275 – SNMPv3
• RFC 2104, Keyed Hashing for Message Authentication
• RFC 2271, An Architecture for Describing SNMP Management Frameworks
• RFC 2272, Message Processing and Dispatching for the Simple Network Management
Protocol (SNMP)
• RFC 2273, SNMPv3 Applications
• RFC 2274, User-Based Security Model (USM) for version 3 of the Simple Network
Management Protocol (SNMPv3)
• RFC 2275, View-Based Access Control Model (VACM) for the Simple Network
Management Protocol (SNMP)
Configuring SNMP
There are several commands and variable which can be set for configuring SNMP. They are listed
below. The basic SNMP v1 parameters can be set by referring to the section on System
Parameters. Most commands here refer to SNMP v3 commands and how the variables for SNMP
v3 can be configured.
Syntax snmp – enter the SNMP Configuration mode
Syntax set snmp type=<v1|all> - define the version of SNMP to use – the option all supports all versions
(v1, v2 and v3) – v1 restricts SNMP to v1 only. By default – SNMP v1only is enabled
Syntax show active-snmp – shows the version of SNMP currently in use
221