Filter
Top Products
MAGNUM 6K SWITCHES, MNS-6K USER GUIDE
snmp_access=enable
web_access=enable
--more—
<additional lines deleted for succinct viewing>
FIGURE 39 – displaying configuration for different modules. Note – multiple modules can be specified on the
command line
Erasing configuration
To erase the configuration and reset the configurations to factory default, you can use the
command ‘kill config’. This command is a “hidden command” i.e. the on-line help and other
help functions normally do not display this command. The ‘kill config’ command resets
everything to the factory default. The reset does not take place till the switch reboots.
It is recommended to save the configuration (using ‘saveconf’
command discussed above) before using the ‘kill config’ command.
The ‘kill config’ will also reset the IP address and all other parameters
as well unless the save option described below is used.
Syntax kill config [save=module-name] – resets the system configuration. The module-name
option does not reset the specific module parameters. The modules are listed below
The module-name can be
Name Areas affected
system IP Configuration, Boot mode, Users settings (e.g.
login names, passwords)
event Event Log and Alarm settings
port Port settings, Broadcast Protection and QoS
settings
bridge Age time setting
stp STP, RSTP, S- Ring and LLL settings
ps Port Security settings
mirror Port Mirror settings
sntp SNTP settings
llan VLAN settings
gvrp GVRP settings
snmp SNMP settings
web Web and SSL/TLS settings
53