Filter
Top Products
MAGNUM 6K SWITCHES, MNS-6K USER GUIDE
Some other definitions are worth noting are primary port. Primary port is the port
over which specific traffic like Multicast (IGMP), unknown Unicast and
broadcast traffic is transmitted. As shown by the add port command, the port with
the lowest priority value has the highest priority and is designated as the primary
port. If traffic analysis is required, it is recommended to mirror the primary port
(and physically disconnect the other ports if all traffic needs to be captured).
If multiple ports have the same priority, the first port physically connected
becomes the primary port. In case the ports are already connected, the port with
the lowest port count becomes the primary port i.e. if ports 4, 5, 6 are designated
as the LACP group, port 4 would become the primary port.
If the primary port fails, the next available secondary port is designated as the
primary port. So in the example above, if port 4 fails, port 5 will be designated as
the primary port.
Magnum 6K25# show lacp
LACP is Disabled.
Magnum 6K25# lacp
Magnum 6K25(lacp)## add port=14,15,16
Error : LACP is disabled.
Magnum 6K25(lacp)## lacp enable
LACP Enabled.
Magnum 6K25(lacp)## add port=13-16
Port(s) added successfully.
Magnum 6K25(lacp)## show lacp
Orphan Ports:
Port Priority Trunk
=====================
13 32768 Link Down
14 32768 Link Down
15 32768 Link Down
16 32768 Peer Not a Trunk
Magnum 6K25(lacp)## del port=16
Port(s) deleted successfully.
Magnum 6K25(lacp)## show lacp
Orphan Ports:
Indicates no LACP BPDU can be received from
this port. This port was in use and was an error to
add this. The next few steps delete this port and add
the proper port. See other messages below.
Need to enable LACP
b
efore
ports can be added to the trunk
group
182