Filter
Top Products
MAGNUM 6K SWITCHES, MNS-6K USER GUIDE
Magnum 6K25(rstp)## rs-ring enable
RS-RING enabled.
Magnum 6K25(rstp)## show rs-ring
RS-RING status : Enabled
RS-RING set on ports : 13,14
Magnum 6K25(rstp)## rs-ring disable
RS-RING disabled.
Magnum 6K25(rstp)## rs-ring del port=13,14
Deleted Ports: 13,14
Magnum 6K25(rstp)## show rs-ring
RS-RING status : Disabled
RS-RING set on ports : NONE
Magnum 6K25(rstp)## exit
Magnum 6K25#
FIGURE 92 – RS-Ring configuration commands
List of commands in this chapter
Syntax authorize <module> key=<security key> - activate the S-Ring capabilities. Don’t forget
to use the “save” command to save the key
Syntax stp – STP Configuration mode
Syntax stp <enable|disable> - Start (Enable) or stop (Disable) STP
Syntax set stp type=<stp|rstp> - set the spanning tree protocol to be IEEE 802.1d or 802.1w
(Spanning Tree Protocol or Rapid Spanning Tree Protocol)
Syntax show active-stp – Display which version of STP is currently active
Syntax show s-ring – show the status of S-Ring status and configuration
Syntax s-ring <enable|disable> - enable or disable S-Ring capabilities
Syntax s-ring learn – start the learning process to discover the ring and the ports which make up the S-
Ring
Syntax s-ring add port=<port1,port2> - define ports which make up the S-ring ports. Note as
discussed earlier, you can create multiple S-Rings on a switch
166