Filter
Top Products
MAGNUM 6K SWITCHES, MNS-6K USER GUIDE
Syntax allow ip=<ipaddress> mask=<netmask> service=<name|list> - allow specific IP
address or range of addresses as a trusted host(s)
Syntax deny ip=<ipaddress> mask=<netmask> service=<name|list> - deny specific IP
address or range of IP addresses
Syntax remove ip=<ipaddress> mask=<netmask> - delete a specific IP address from the access or
trusted host list
Syntax removeall – remove all IP addresses of trusted hosts
Syntax show ip-access – display all trusted hosts
Syntax clear <history|log [1..5 |informational |activity |critical |fatal |debug] |terminal
|arp|portstats|addr] – clear command to clear various aspects of the MNS-6K information – most
notably “clear addr” – clears the addresses learnt or “clear log” to clear the logs (and the type of logs)
Chapter 6 – Access Using Radius
Syntax auth configuration mode to configure the 802.1x parameters
Syntax show auth <config|ports> show the 802.1x configuration or port status
Syntax authserver [ip=<ip-addr>] [udp=<num>] [secret=<string>] define the RADIUS server
– use UDP socket number if the RADIUS authentication is on port other than 1812
Syntax auth <enable|disable> enables or disables the 802.1x authenticator function on MNS-6K switch
Syntax setport port=<num|list|range> [status=<enable|disable>]
[control=<auto|forceauth|forceunauth>] [initialize=<assert|deassert>] setting the
port characteristic for an 802.1x network
Syntax backend port=<num|list|range> supptimeout=<1-240>] [servertimeout=<1-240>]
[maxreq=<1-10>] configure parameters for EAP over RADIUS
port – [mandatory] – port(s) to be configured
supptimeout – [optional] This is the timeout in seconds the authenticator waits for the
supplicant to respond back. Default value is 30 seconds. Values can range from 1 to 240
seconds.
servertimeout – [optional] This is the timeout in seconds the authenticator waits for the
backend RADIUS server to respond back. The default value is 30 seconds. Values can
range from 1 to 240 seconds.
263