Filter
Top Products
MAGNUM 6K SWITCHES, MNS-6K USER GUIDE
Syntax set stp type=<stp|rstp> - set the spanning tree protocol to be IEEE 802.1d or 802.1w (Spanning
Tree Protocol or Rapid Spanning Tree Protocol)
Syntax show active-stp – Display which version of STP is currently active
Syntax show s-ring – show the status of S-ring status and configuration
Syntax s-ring <enable|disable> - enable or disable S-ring capabilities
Syntax s-ring learn – start the learning process to discover the ring and the ports which make up the S-ring
Syntax s-ring add port=<port1,port2> - define ports which make up the S-ring ports. Note as discussed
earlier, you can create multiple s-rings on a switch
Syntax s-ring del port=<port1,port2> - remove the switch from S-ring topology by eliminating the end ports
on the switch
Syntax lll <enable|disable> - enable or disable LLL on the switch
Syntax lll add port=<port|list|range> - enable LLL on the list of specified ports
Syntax lll del port=<port|list|range> - disable LLL on the list of specified ports
Syntax show lll – display the status of LLL
Syntax rstp – STP Configuration mode
Syntax rstp <enable|disable> - Start (Enable) or stop (Disable) STP
Syntax set stp type=<stp|rstp> - set the spanning tree protocol to be IEEE 802.1d or 802.1w (Rapid
Spanning Tree Protocol)
Syntax show active-stp – Display which version of STP is currently active
Syntax show rs-ring – show the status of RS-ring status and configuration
Syntax rs-ring <enable| disable> - enable or disable RS-ring capabilities
Syntax rs-ring add port=<port1,port2> - define ports which make up the RS-ring ports. Note as
discussed earlier, you can create multiple RS-rings on a switch
Syntax rs-ring del port=<port1,port2> - remove the switch from RS-ring topology by eliminating the end
ports on the switch
269