Filter
Top Products
MAGNUM 6K SWITCHES, MNS-6K USER GUIDE
STP CONFIGURATION
-----------------
Spanning Tree Enabled(Global) : YES
Spanning Tree Enabled(Ports) : YES, 9,10,11,12,13,14,15,16
Protocol : Normal STP
Bridge ID : 80:00:00:20:06:25:ed:80
Bridge Priority : 32768
Bridge Forward Delay : 15
Bridge Hello Time : 2
Bridge Max Age : 20
Root Port : 0
Root Path Cost : 0
Designated Root : 80:00:00:20:06:25:ed:80
Designated Root Priority : 32768
Root Bridge Forward Delay : 15
Root Bridge Hello Time : 2
Root Bridge Max Age : 20
RSTP CONFIGURATION
-----------------
Rapid STP/STP Enabled(Global) : NO
Magnum6K25(stp)## show stp ports
STP Port Configuration
--------------------------------------------------------------------------------------------------------------------------
Port# Type Priority Path Cost State Des. Bridge Des. Port
--------------------------------------------------------------------------------------------------------------------------
09 TP(10/100) 128 100 Forwarding 80:00:00:20:06:25:ed:80 80:09
10 TP(10/100) 128 100 Disabled 80:00:00:20:06:25:ed:80 80:0a
11 TP(10/100) 128 100 Disabled 80:00:00:20:06:25:ed:80 80:0b
12 TP(10/100) 128 100 Disabled 80:00:00:20:06:25:ed:80 80:0c
13 TP(10/100) 128 19 Forwarding 80:00:00:20:06:25:ed:80 80:0d
14 TP(10/100 128 100 Disabled 80:00:00:20:06:25:ed:80 80:0e
15 TP(10/100) 128 100 Disabled 80:00:00:20:06:25:ed:80 80:0f
16 TP(10/100) 128 100 Disabled 80:00:00:20:06:25:ed:80 80:10
Magnum6K25(stp)##
FIGURE 77 – Enabling STP
Syntax priority [port=<number|list|range>] value=<0-255 | 0-65535> - specifies the
port or switch level priority. When a port(s) are specified the priority is associated with ports and
their value is 0-255. If no ports are specified, then the switch (bridge) priority is specified and its
value is 0-65535
Syntax cost port=<number|list|range> value=<0-65535> - cost is specific to a port and the
port(s) have to be specified
Syntax port port=<number|list|range> status=<enable|disable> - specific ports may
not need to participate in STP process. These ports typically would be end-stations. If you are not
sure – let MNS-6K software make the decisions
Syntax timers forward-delay=<4-30> hello=<1-10> age=<6-40> - change the STP
Forward Delay, Hello timer and Aging timer values
128