Filter
Top Products
Solution
Make sure each of the power cords is firmly connected, and wait a few seconds for
the HP all-in-one to turn on. If this is the first time you have turned on the HP all-
in-one, it can take up to a minute to turn on. Also, if the HP all-in-one is plugged in
to a power strip, make sure the power strip is turned on.
My USB cable is not connected
Solution
You must first install the software that came with your HP all-in-one before
connecting the USB cable. During installation, do not plug in the USB cable until
prompted by the onscreen instructions. Connecting the USB cable before prompted
can cause errors.
Once you have installed the software, connecting your computer to your HP all-in-
one with a USB cable is straightforward. Simply plug one end of the USB cable into
the back of your computer and the other into the back of the HP all-in-one. You can
connect to any USB port on the back of your computer.
Note AppleTalk is not supported.
I received a message on the color graphics display to attach the control panel
overlay
User Guide 151
Troubleshooting information