Filter
Top Products
6 When prompted, press 1 for Yes or 2 for No.
Print a Self-Test Report to confirm the language and country/region:
1 Press Setup.
2 Press 1, and then press 4.
This selects Print Report, and then selects Self-Test Report.
The wrong measurements are showing in menus on the color graphics display
Solution
You may have selected the incorrect country/region when setting up your HP all-
in-one. The country/region you select determines the paper sizes shown on the
color graphics display.
To change the country/region, you must first set the default language again.
Usually, you set the language and country/region when you first set up the HP all-
in-one. However, you can change these settings at any time by using the following
procedure:
1 Press Setup.
2 Press 7, and then press 1.
This selects Preferences, and then selects Set Language & Country/Region.
A list of languages appears. You can scroll through the list of languages by
pressing the
and arrows.
3 When your language is highlighted, press OK.
4 When prompted, press 1 for Yes or 2 for No.
The countries/regions for the selected language appear. Press
or to
scroll through the list.
5 Use the keypad to enter the two-digit number for the appropriate country/
region.
6 When prompted, press 1 for Yes or 2 for No.
Print a Self-Test Report to confirm the language and country/region:
1 Press Setup.
2 Press 1, and then press 4.
This selects Print Report, and then selects Self-Test Report.
I received a message on the color graphics display to align the print cartridges
Solution
The HP all-in-one prompts you to align cartridges every time you install a new print
cartridge. For more information, see Align the print cartridges.
Note If you remove and reinstall the same print cartridge, the HP all-in-one will
not prompt you to align the print cartridges. The HP all-in-one remembers
the alignment values for that print cartridge, so you do not need to realign
the print cartridges.
I received a message on the color graphics display that the print cartridge
alignment failed
Cause
The incorrect type of paper is loaded in the input tray.
User Guide 153
Troubleshooting information