Filter
Top Products
6 Push against the top of the face plate (1) with your thumb as you pull the
bottom away from the right side of the HP all-in-one with your fingers, as
shown in Figure 4.
Use a slight twisting motion to help release the face plate on the right side.
Warning Do not pull the face plate all the way off yet. There is a
plastic catch on the far left inside of the face plate that helps secure the
face plate in place. If you pull the face plate straight off, you might
damage the plastic catch on the inside of the face plate.
Figure 4
1 Face plate
7 As shown in Figure 5, slide the face plate left (1) until the plastic catch on the
left side is not touching any part of the HP all-in-one, then pull the face plate
away from the device (2).
Figure 5
To clean the rollers or separator pad
1 Use the blue-green handle (1) shown in Figure 6 to lift the pick assembly (2).
Chapter 16
176 HP Officejet 7300/7400 series all-in-one
Troubleshooting information