Fuser
CAUTION: The fuser might be hot. Allow enough time after turning off the product power for the
fuser to cool.
1. Open the right-door assembly.
2. Grasp the handles and squeeze the blue release levers (callout 1).
Figure 2-5 Remove the fuser
2
1
3. Pull the fuser (callout 2) straight out of the product to remove it.
Reset the New Fuser Kit setting at the control panel
NOTE: Use this procedure to reset the internal page count if a replacement fuser is installed.
1. At the control panel, press the Home button .
2. Open the following menus:
●
Administration
●
Manage Supplies
●
Reset Supplies
●
New Fuser Kit
3. Use the Down arrow button
to highlight the Yes item, and then press OK to select it.
ENWW
Removal and replacement procedures
93